- Artec studio color ply manual#
- Artec studio color ply registration#
- Artec studio color ply software#
Specify a suitable value for your system, or clear this checkbox if you require no warnings of this kind. This limit reduces the potential for the computer to hang up. This checkbox instructs the application to display a warning if you exceed the maximum number of polygons to be inpainted at one time. Texture-healing brush: warn if over _ polygons selected. If you are familiar with these algorithm peculiarities, you may disable these notifications. To this end, mark the Override default depth range checkbox and enter new range values. If you are using an Artec L scanner or 3D-sensor and high accuracy is of lesser importance, however, you can adjust the depth boundaries manually, allowing you to scan closer to or further from the object than the recommended distances indicate. The scanner model determines these values. Therefore, you should position the scanner as close as possible to the object without crossing the cutoff plane.ĭefault settings for each 3D scanner contain minimum and maximum limits within which you can position the cutoff planes. On the other hand, if the scanner is too far away, various types of 3D “noise” will appear in the scene, complicating the postprocessing effort and affecting the final results. If it’s too close to the object, it may fail to capture all or part of the object. For details regarding these buttons, see Scanner Buttons and Capture Modes. The first option is the Trigger mode for device button checkbox, which changes the button behavior on the Artec MH and Artec MHT scanners. The Capture section covers settings related to the trigger button for the Artec MHT scanner, as well as the scanning-depth range and individual frames acquired during the scan.
When exporting point-cloud scans (Artec point cloud and Leica Geosystems Cyclone Point Cloud), application will ignore the specified units. The Default import units and Default export units dropdown lists determine the default measurement units for importing and exporting models. In this case, the unit-selection dialog will only appear if the model dimensions are below the threshold value. If in most cases you import data in a particular measurement unit, but you might occasionally import models created using another unit, you should enable the Only if object is less than _ mm option and enter the threshold value. Artec Studio supports units of millimeters, centimeters, inches and meters. Selecting the Show unit-selection dialog on import option enables you to choose on import which measurement unit was used to create the scan (see Figure 133).
Artec studio color ply software#
The software applies these settings only when importing or exporting a model or a point-cloud scan. If you need to import or export a model in other units, change the settings under Units. In Artec Studio, all software operations use millimeters as the default measurement unit. Notes Regarding Scanner-Calibration Files.Correcting Field of View for EVA, MHT, MH and L Scanners.Surface-Consistency Detection During Import.Registering Artec Studio as Default Viewer.Using Sections to Measure Area and Volume.Placing Objects on Coordinate Plane (Positioning Tool).Moving, Rotating and Scaling (Transformation Tool).
Artec studio color ply manual#
Texture-Healing Brush: Manual Inpainting.
Artec studio color ply registration#
Representation of Normals and Boundaries.Global Coordinate System and Rotation Center.Notes on Scanning With Third-Party 3D Sensors.Using Photogrammetry Solution (Scan Reference).Auto-align new scans with those marked in Workspace.Base Removal: Erasing a Supporting Surface.Selecting and Preparing Objects for Scanning.Managing Artec 3D Scanners and Products.3D Scanner Activation Using Artec Installation Center.Buttons and LED Indicators for Eva and Spider.